
www.axxessid.com
Installation Guide
AX200 Installation Guide – May 2008
P a g e 3
12. Click Add. Select the type of
reader (with or without PIN) then
click next. Enter a suitable name
for the door location being
added. Then click OK. After a
brief period of time the add
wizard will be completed. Access
point specific settings such as
lock times, IN/Out configuration
may be set under Access point /
Access point. When a new
AX100 is added the access point
screen will be displayed. Note if
two AX100’s are connected to
the AX200 after 15 seconds the
Add wizard will appear again for
Device two to be added.
13. Close the TCP/IP settings screen and close the device manager screen or access point
screen.
14. From the main screen click on the cardholder button and add a card(s) When the cardholder
screen is exited the information will be downloaded to the relevant controllers and the door
will lock.
15. Power up the next AX200 to be added and repeat steps 6 – 13 until all controllers are
configured.
T C P / I P C o n f i g u r a t i o n ( F i x e d I P A d d r e s s )
Refer to this section if the PC does not have a fixed IP address or for additional IP address
information.
To specify a fixed IP address
Click the Windows Start button then select setting and select control panel.
Double Click on the Network icon. In the components box scroll down to
TCP/IP Network card name and click on it. (On Windows XP the control
panel may be displayed directly from the Windows Start button) Click on
Properties Button.
Select the IP Address Tab
Ensure that the system is set to Specify an IP Address and that a valid IP
address is in the IP address box. (Note – most organisations allow fixed IP
address ranges, and a suitable IP number is normally obtained from the
network administration manager) Enter a valid subnet mask address.
Typically this is set to 255.255.255.0
Click OK or Apply.
Click OK to exit the network setup and close the system control panel
window. If prompted to reboot or to insert the Windows installation disk
please follow the on-screen prompts.
Komentarze do niniejszej Instrukcji