Axxess AX200 Instrukcja Użytkownika Pobierz pdf (Strona 3)

www.axxessid.com

Installation Guide

AX200 Installation Guide – May 2008

P a g e 1

This Installation Guide details the initial setup and steps to get the AX200 software operational. For

further information and additional features please refer to the AX200 software manual.

Complete software installation and TCP/IP configuration must be performed whilst logged into

Windows with full Windows Administration rights.

A X 2 0 0 S o f t w a r e S e t u p

1. Install the AX200 software. Insert the CD, if auto run is disabled then click Start and select

Run. Enter d:\setup.exe in the text box and click OK. (Note substitute the CD-ROM drive letter

in place of d) Follow the on screen instructions to complete the installation.

2. Ensure that the PC is connected

to the network and the AX200’s

are connected to the network but

powered off.

3. Ensure that the PC has a fixed

IP address.

4. Start the AX200 software and

enter the user name and

password to login. The default

user name is “1” and the default

password is “1”. Allow the

software to initialise.

5. Power up the first AX200 and the

AX100(s) connected to this

controller.

6. Click on the Access point button located near the bottom left on the screen.

7. Click on the last Tab Sheet labelled as Device Manager.

8. Wait for approximately 10

seconds and the device

manager will seek all of the

AX200’s connected to the

network that are powered on.

New AX200’s will be displayed

in red; previously configured

AX200’s will be displayed grey.

(AX200’s previously configured

but not online will be displayed

as Grey with a red cross)

Double click on the Red

AX200.

1 2 3 4 5 6 7 8 9 10

Brak uwag

Axxess AX200 Instrukcja Użytkownika Strona 3